diff --git a/drivers/usb/core/hub.c b/drivers/usb/core/hub.c
index db7683e2d34c6201dd79b0df7936a9438d0b22f1..679b2ce014080faa974a02a3bf122fba350b9b1f 100644
--- a/drivers/usb/core/hub.c
+++ b/drivers/usb/core/hub.c
@@ -3304,7 +3304,7 @@ static int finish_port_resume(struct usb_device *udev)
 /*
  * There are some SS USB devices which take longer time for link training.
  * XHCI specs 4.19.4 says that when Link training is successful, port
- * sets CSC bit to 1. So if SW reads port status before successful link
+ * sets CCS bit to 1. So if SW reads port status before successful link
  * training, then it will not find device to be present.
  * USB Analyzer log with such buggy devices show that in some cases
  * device switch on the RX termination after long delay of host enabling
@@ -3315,14 +3315,17 @@ static int finish_port_resume(struct usb_device *udev)
  * routine implements a 2000 ms timeout for link training. If in a case
  * link trains before timeout, loop will exit earlier.
  *
+ * There are also some 2.0 hard drive based devices and 3.0 thumb
+ * drives that, when plugged into a 2.0 only port, take a long
+ * time to set CCS after VBUS enable.
+ *
  * FIXME: If a device was connected before suspend, but was removed
  * while system was asleep, then the loop in the following routine will
  * only exit at timeout.
  *
- * This routine should only be called when persist is enabled for a SS
- * device.
+ * This routine should only be called when persist is enabled.
  */
-static int wait_for_ss_port_enable(struct usb_device *udev,
+static int wait_for_connected(struct usb_device *udev,
 		struct usb_hub *hub, int *port1,
 		u16 *portchange, u16 *portstatus)
 {
@@ -3335,6 +3338,7 @@ static int wait_for_ss_port_enable(struct usb_device *udev,
 		delay_ms += 20;
 		status = hub_port_status(hub, *port1, portstatus, portchange);
 	}
+	dev_dbg(&udev->dev, "Waited %dms for CONNECT\n", delay_ms);
 	return status;
 }
 
@@ -3434,8 +3438,8 @@ int usb_port_resume(struct usb_device *udev, pm_message_t msg)
 		}
 	}
 
-	if (udev->persist_enabled && hub_is_superspeed(hub->hdev))
-		status = wait_for_ss_port_enable(udev, hub, &port1, &portchange,
+	if (udev->persist_enabled)
+		status = wait_for_connected(udev, hub, &port1, &portchange,
 				&portstatus);
 
 	status = check_port_resume_type(udev,