firmware: arm_scmi: Harmonize SCMI tracing message format

After the recently added new scmi_msg_dump traces, the general format of
the various other SCMI traces are not consistent.

As an example the full traces of a simple PERF_LEVEL_SET:

 | cpufreq-set-276  scmi_xfer_begin: transfer_id=145 msg_id=7 protocol_id=19 seq=145 poll=0
 | cpufreq-set-276  scmi_msg_dump: pt=13 t=CMND msg_id=07 seq=0091 s=0 pyld=000000008066ab13
 | cpufreq-set-276  scmi_xfer_response_wait: transfer_id=145 msg_id=7 protocol_id=19 seq=145 tmo_ms=5000 poll=0
 |      <idle>-0    scmi_msg_dump: pt=13 t=RESP msg_id=07 seq=0091 s=0 pyld=
 |      <idle>-0    scmi_rx_done: transfer_id=145 msg_id=7 protocol_id=19 seq=145 msg_type=0
 | cpufreq-set-276  scmi_xfer_end: transfer_id=145 msg_id=7 protocol_id=19 seq=145 status=0

... where the same information is being reported using different names
(protocol_id= vs pt=) and even worst different bases, which is hard to
read and to parse.

So let us unify them, using the same naming and ordering of the fields
(wherever possible) and moving all the protocol related fields to base-16
while keeping in base-10 timeouts, res_id and values, so that the new
traces would be like:

 | cpufreq-set-274  scmi_xfer_begin: pt=13 msg_id=07 seq=0092 transfer_id=92 poll=0
 | cpufreq-set-274  scmi_msg_dump: pt=13 t=CMND msg_id=07 seq=0092 s=0 pyld=000000008066ab13
 | cpufreq-set-274  scmi_xfer_response_wait: pt=13 msg_id=07 seq=0092 transfer_id=92 tmo_ms=5000 poll=0
 |         cat-256  scmi_msg_dump: pt=13 t=RESP msg_id=07 seq=0092 s=0 pyld=
 |         cat-256  scmi_rx_done: pt=13 msg_id=07 seq=0092 transfer_id=92 msg_type=0
 | cpufreq-set-274  scmi_xfer_end: pt=13 msg_id=07 seq=0092 transfer_id=92 s=0

Link: https://lore.kernel.org/r/20220818132309.584042-2-cristian.marussi@arm.com


Signed-off-by: Cristian Marussi <cristian.marussi@arm.com>
Signed-off-by: Sudeep Holla <sudeep.holla@arm.com>